Computer Science Project

custom essay writing service
Question

Computer Science Project
Part-1:
Write an ARM assembly code to implement a loop for calculating factorial of an integer
N. For example if the input N from the standard input is equal to 5, it should return 120
(i.e, 5! ); the result (i.e, 120) should be printed on the standard output.
Part-2:
1. Repeat part-1 for N factorial, by adding code to measure program execution time in
milliseconds. This can be achieved by reading system time and storing it into a General
Purpose Register (GPR), or preferably in memory location, and before the program exits
read system time again the difference is the time elapsed for execution. Write the elapsed
time in the output file on the same line as the factorial number in tabular form. Example:
Number Factorial Time elapsed (ms)
———- ———– ———————-
5 120 351
Once you have your program working and creating the proper out file as shown in the
example above, move to next step.
2. Repeat step 1 using by having the following numbers in your input file to calculate their
factorial and the output file must have one entry for each number as shown in the
example table in previous step. The numbers to use in your input file are:
0, 1, 3, 5, 5, 7, 8, 9, 10, 11, 12
Part-3:
1. Open another input file e.g summation-input that contains list of integers, do summation
for each integer (use loops as you did in Project 1). For each summation measure
program execution time, also measure the whole list integers summation time in
milliseconds. This can be achieved by reading system time and storing it into two
different General Purpose Registers (GPRs), or preferably in memory locations, and after
each integer summation read system time again the difference is the time elapsed for
executing that summation. Write the elapsed time in the summation-output file on the
same line as the summation number in tabular form. Example:
Number Summation Time elapsed (ms)
———- ———– ———————-
5 15 201
———————————————————————————————————————
Page 2 of 2
Do step three for all of the following numbers in your summation-input file to calculate
their summation and the summation output file must have one entry for each number as
shown in the example table above, also the last line in the table must have the total
elapsed time for do doing all integer summation using system time. The numbers to use
in your summation input file are:
0, 1, 2000, 4000, 6000, 8000, 10000, 12000, 14000, 16000, 18000, 20000
Note: add appropriate comments to your assembly code explaining what each instruction
does in the context of your program.
Computer Science homework help
This is property of essay help USA. We provide the best online research help to individuals needing our assistance. Log in for Research paper writing help